![]() ![]() Eventually, it should begin to move and you may be able to get a narrow flathead screwdriver under one end to prise the nut out from its slot. The idea is to rock the nut back and forth in its slot sufficiently to break any glue joints. Unless you’re planning to cut loads of nuts, a set of nut files might be prohibitively expensive The craft knife is for scoring the finish prior to nut removal. You can buy bone and Graphtec nut blanks from Allparts UK. Move the block to the other edge and tap it again, using very little force. After removing the strings, place a wooden block against one of the long edges of the nut and tap the block lightly with a mallet. Nuts are usually glued in place, so you must proceed with care. ![]() You’ll have to score the finish around the edges of the nut very carefully to ensure you don’t remove chunks of finish along with the nut. Many factories fit nuts prior to the finishing stage, so the sides of the nut will be covered in lacquer or paint. ![]() Instead, we’re talking about drop-in replacements from suppliers such as Allparts UK, that are pre-slotted and will require only minimal adjustments in order to fit correctly. That requires some serious luthier chops as well as specialist tools. We should first point out that we’re not discussing how to cut, carve and slot a nut from a bone blank. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |